|
#1
|
|||
|
|||
![]()
Hi all
just want to tell everyone how great a service i got from LESRO models i ordered some bits from there yesterday afternoon and i got them thismorning i couldnt belive it SO CHEERS LESRO ![]() |
#2
|
||||
|
||||
![]()
I guess you need to know that Lesro are in Dorset and you live in Hull, what's that 300 miles?
__________________
Nortech is ACE! |
#3
|
|||
|
|||
![]()
i new that dan
![]() |
#4
|
|||
|
|||
![]()
i had the same trust with DMS-Racing until they stung me for 2 sets of tyres and i only wanted one set. only sent me the one set too
![]() |
#5
|
|||
|
|||
![]()
lesro should be destroyed!! cheated me on a toruing car (sold it to me claiming everthing was ok), the hexes were US and once i had purchased us hex drivers, the hexes on the car had no life in them !!
They also sold me a faulty charger!! Not ony that but they charged me a fourtune (£18) for rewireing INCORECTLY a speed controller. |
#6
|
||||
|
||||
![]() Quote:
Faulty charger can happen. It's a pain but how did they react after you told them it was faulty? (I don't think they intentionally sold you something faulty... that would be kinda stupid for a shop ![]() What exactly did they rewire? The whole controller including the wires on the circuit board or just initial setup? |
#7
|
|||
|
|||
![]()
the car was a second hand losi (xxxs), and the hexes simply were completely worn out (even if they claimed nothing eas wrong) so no matter what you did the hexes would not turn (and yes i could have used a dremel but dude there were around 40 srews which many were inaccessable and then i would have had to pay for new ones) also they refused to accept credit card and only wanted cash (so that they would not have to pay bank charges) the charger simply would not charger more than around 2000mah (they claimed it would do over 5000mah) and the speedo was an lrp qc which they screwed up the deans lead to the battery and motor, i ended up sending the speedo to lrp which they sent back saying nothing was faulty, so i thought that the wiring (done at Lesro) was faulty and i had to buy more wire, and new deans and had to redo it myself! And only now does it work!
|
![]() |
Thread Tools | |
Display Modes | |
|
|