|
#1
|
||||
|
||||
![]()
Got my car nearly setup just having a problem with the rear stepping out as you come on the power after a corner, this is on the slippy floor part of the track (although that is most of the track
![]() 0 degree camber 3 degree per side toe in 22mm ride height 5.5 turn spring 50 wt oil kit piston middle hole on rocker any help or suggestions appreciated peter |
#2
|
||||
|
||||
![]()
Add some more toe-in, soften the oil a little.
Are there many jumps? What tyres are you using? G
__________________
Graham North http://www.atomic-carbon.co.uk https://www.facebook.com/atomiccarbon https://www.facebook.com/nortechracing |
#3
|
||||
|
||||
![]()
Yes there's a few jumps and i'm using mini spikes.
peter |
#4
|
||||
|
||||
![]()
BIG jumps?
Spikes suit the Pred better than pins. Try what I suggested, let me know how it goes. G
__________________
Graham North http://www.atomic-carbon.co.uk https://www.facebook.com/atomiccarbon https://www.facebook.com/nortechracing |
#5
|
||||
|
||||
![]()
Went down to 40 wt oil and added 0.5 degree of camber, totally different car to drive, went so much better.
cheers for the help peter |
#6
|
||||
|
||||
![]()
Could you also share your setup for the front section?
Thx ![]() |
#7
|
||||
|
||||
![]() Quote:
G
__________________
Graham North http://www.atomic-carbon.co.uk https://www.facebook.com/atomiccarbon https://www.facebook.com/nortechracing |
#8
|
||||
|
||||
![]()
at the minute on the front i've got
1 degree toe out 0 degree camber 30wt oil kit piston 6.5 turn spring castor 0 washers behind upper arm 16mm ride height |
![]() |
Thread Tools | |
Display Modes | |
|
|