rear motor

[reg]

Hi,im going to give gnarly dogs rear motor setup ago,i was just wondering as it says gnarly dogs weight system on the setup sheet what this is and were you put the weight,
thanks
Mark

[Gnarly Old Dog]

I just made up some weights to fit either side of the short LiPo along with a plate that fits underneath the battery.

In rear motor config, the ESC shelf / battery box doesn't allow for any under LiPo weight (depending on the height of the LiPo) - but with the 96mm battery fitted fully forward, you can still fit weights underneath it.

The 150g Gnarly is a combination of an 80g under LiPo weight plus the sdie LiPo weights (each 35g).

HTH

[reg]

thanks for that,intersting that even on the rear motor you still run weight at the rear and non in the front,i hav a play with some lead

[Gnarly Old Dog]

I wouldn't say the weight was at the rear.

I ran the weight under the battery but with the short battery in the fully forward position - so it didn't go underneath the ESC shelf at all

The weights at the side of the battery are pretty evenly spaced around the centre of gravity.

Although I had no scales to prove it, I'd say that the added weight actually moved the C of G very slightly forward if anything.

[reg]

thanks Gnarly,very helpfull as always