Part TLR1072

[Martyn (Bomber)]

Just a word of advise about this part, the grub screws don't line up with the front hinge pins and you can end up snapping off your hex driver in the grub screw, like I just done

[reg]

there not ment to line up,there just ment to run alongside it and the cut out in the pin stops the pin coming out,if i understand you correcty,you just want a dob of thread lock,it doesnt need doing up within an inch of its lifelike i usualy do

[Martyn (Bomber)]

The grub screw is suppose to sit in the side of the indent on the hinge pin like the standard one does, these don't do this unless I have a faulty part

I'll give HH a call on Monday

[reg]

i see what your saying now,the hole it to close to the hinge pin,hope you get it sorted

[Martyn (Bomber)]

Originally Posted by reg

i see what your saying now,the hole it to close to the hinge pin,hope you get it sorted

Thats the one I'll update this thread when I speak to HH, just to let everyone know if the problem is just down to my part (hopefully) or all parts.