|
#1
|
||||
|
||||
![]()
Been using deans for ages debating on converting to corally connectors whitch ones do you guys go for?
Luke
__________________
LB Racing ~ RCBearings ~ RCDisCo~ SMD |
#2
|
||||
|
||||
![]()
I prefer the Corally 4mm male & female
but if you use these it's best to wire them up so you have one wire that is shorter than the other so they don't reach the wrong terminal
__________________
o0ple Trader Feedback NE Venue's New & Old my space on YouTube CFR RCTV Channel Glenn Atterton BRCA 2005 1/10th Off-Road Veterans Champion LMP12 National Champion 2003/2004 / F3 class |
#3
|
||||
|
||||
![]()
Corally's for me, used them for years now. I find you can make a much neater electrics setup using them. Just make sure you make one of the leads too short to reach the opposite batt terminal.
__________________
Who needs talent when you have a Yokomo! ![]() |
#4
|
||||
|
||||
![]()
Depends on the packs you use.
Corallies for packs which have corally sockets. Deans for stick packs that have a connector on the end of a wire.
__________________
David Allen - www.digitrc.co.uk - Xevo - Much-More Racing UK |
#5
|
||||
|
||||
![]()
i use both but prefer corally by miles deans can get damaged on the male pins where as corally only get damaged if you squash them.
__________________
|
#6
|
||||
|
||||
![]() Quote:
been using them since late 93 when I got sick of the larger PowerPole connectors, not sure if Deans were out in 93
__________________
o0ple Trader Feedback NE Venue's New & Old my space on YouTube CFR RCTV Channel Glenn Atterton BRCA 2005 1/10th Off-Road Veterans Champion LMP12 National Champion 2003/2004 / F3 class |
#7
|
||||
|
||||
![]()
Corallys have slightly higher current rating than Deans, but have the downside of being easy to connect the wrong way around if your not careful!
__________________
AKA: Andy Nancollis 1/10th drives: Yokomo BMax2MR & BMax4 1/16th drive: Carisma GTB Racing in South West: http://www.mendiprcraceway.co.uk/ Racing in Wales: www.caldicotrcracers.co.uk Kept running by: Yokomo via MB Models & www.tracksidespares.co.uk Shells by Square Crabs |
#8
|
||||
|
||||
![]()
I started off with the B44 on deans with saddles (obv)
Then I moved to the Cat SX which was a pain with the extra wire so when I swapped to sticks I got corrally's and routed my wiring so it didn't go through the belt. Then back on the durango I decided to go corally as this would make a tidier install |
#9
|
||||
|
||||
![]()
where do you get them from?
|
#10
|
||||
|
||||
![]()
Think i may switch to corallys then
![]() ![]()
__________________
LB Racing ~ RCBearings ~ RCDisCo~ SMD |
![]() |
Thread Tools | |
Display Modes | |
|
|