|
||
|
 |
|
||||||||||||||||||
|
#1
25-01-2009
|
||||
|
||||
Nosram Matrix evo problems??
Hi Guys, having a bit of trouble with my Matrix evo, it's been in my TC and worked fine for a year or so, put it in my x6 and having probs!
From low rpm it cuts out, you turn the rotor and it works fine then every now and again it cuts out from low rpm and stops, sounds like cogging to me? Iv tried a new sensor lead, new motor and set it up again Any ideas or shall I send it to Mirage?? 
|
|
#2
10-01-2011
|
||||
|
||||
|
Sorry to drag up and old thread but I have a Nosram matrix evo that is doing exactly the same thing.
Did you manage to get it sorted? Tried different sensor leads and motors but no joy.
|
|
#3
10-01-2011
|
||||
|
||||
|
Blimey that was a while ago! I think it was a problem with the board in the motor, some solder ran down the tabs and caused problems.
Since then I have bought about 3 speedos! Try another motor first I reckon.
|
|
#4
10-01-2011
|
||||
|
||||
|
Tried 4 different motors.
Its defo the esc. Will need to get it looked at.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
