|
||
|
 |
|
||||||||||||||||||
|
#1
05-03-2011
|
||||
|
||||
pinion sizes and dp
hi, does anyone know the shaft size on the anderson escape motors,
i have some small pinions that fit on my brushless but are too small for the escape motor i have some for my 18th novak motor but they are too large, anyone any idea's on the size i need,??? also what dp do i need so the pinion meshes ok with the standard lrp shark 49 tooth spur??? thanks for any responses 
|
|
#2
05-03-2011
|
||||
|
||||
|
Ive just measured a couple of old ones i have and they are 2.3mm shaft size,you need .6 module for a shark
HTH
__________________
~Rick Evans~ ~LRP~shark st ft~lwb~ ~Carisma GT14B pro~ ~Schumacher KF2~ ~Schumacher Atom~ ~BSR Basher-RallyX~ ~Ascociated RC8.2e RallyX~ ~TeamC T8EV3 RallyX~ phat bodies worm-racing http://www.mendiprcraceway.co.uk
|
|
#3
05-03-2011
|
|||
|
|||
|
rcmodelimports
Rcmodelimports has blaze pinions for most motors. Cheap too!
I am sure if you email they will confirm exactly what you need for that motor.
|
|
#4
05-03-2011
|
||||
|
||||
|
Quote:
|
|
#5
12-03-2011
|
||||
|
||||
|
think i slightly over ordered, lol,
purchased 3 x 12 tooth pinions from cain at rcmodelimports then i rang up rw racing and ordered 2x9, 2x10, 2x11 and 2x12 pinions... oh well i shouldnt run out any time soon, lol, suppose it means i can put a pinion on each of my motors that are mounted on motor mounts and do quick motor changes if i need to
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
