|
||
|
 |
|
||||||||||||||||||
|
#1
30-12-2010
|
|||
|
|||
Drilling axle shaft
Hi
The X6 sq takes 1.5mm drive pins. Has anyone tried drilling the axle shaft slightly to take 2mm drive pins as they come in a longer length or are they too hard to drill. Didnt want to start messing around until I got some opinions. Thanks 
|
|
#2
30-12-2010
|
||||
|
||||
|
How long pins do you want?
__________________
Graham North http://www.atomic-carbon.co.uk https://www.facebook.com/atomiccarbon https://www.facebook.com/nortechracing 
|
|
#4
31-12-2010
|
||||
|
||||
|
Well if you head over to: http://www.nortechracing.com/
The axle pins are back in stock there. The sizes are: "Front" - 9.5mm - these fit 4wd front hexes "Rear" - 11mm - these fit AE, Losi, Tamiya, JC rear wheels "Cat SX" - 12.7mm - these fit Cat SX front and rear wheels and fit in AE and Losi wheels also. I use the Cat SX pins in my rear wheels. They are a little too long for JC wheels but can be trimmed. They are also perfect for SC10 wheels to help stop them stripping.
__________________
Graham North http://www.atomic-carbon.co.uk https://www.facebook.com/atomiccarbon https://www.facebook.com/nortechracing
|
 |
| Thread Tools | |
| Display Modes | |
|
|
X-Factory
Linear Mode
