ZX5 Slipper Measurement

[tc2k]

Would anyone be able to measure the length of the slipper shaft from the end where the bevel gear goes on to the risen ridge behind it?

[bert digler]

Originally Posted by tc2k

Would anyone be able to measure the length of the slipper shaft from the end where the bevel gear goes on to the risen ridge behind it?

yeah

[tc2k]

Well if anyones rebuilding a car it would be a simple thing to do. Very constructive to just come on and take the mick.

[KyoshoK]

why u need measurement for? i got a brand new one, if u need the measurement for a good reason i'll measure it for you

[tc2k]

Im looking to convert my Evo III to an offroad buggy and Ill hopefully use the ZX5 slipper and I need to see how itd fit and what Id need to modify.
EDIT: If you DO measure it, could you also measure the distance from the pin hole to the end. Thanks

[KyoshoK]

ok i'll get back to u

[tc2k]

Just wondered, did you get the measurement mate

[KyoshoK]

from start hole 6.6mm

from middle of pin hole to the end 7.35mm


width of hole is 1.5mm