Nosram evolution istc

[Richard Law]

Hi, how do i get into the casing on the above, ive taken the 2 x little screws out, but nothing seems to part, i need to relace one of the cap wires?
Any guidence appreciated
Thanks

[Rich D]

remove the screws from the fan and leave hanging on its wire. Then take the 2 bottom screws out, the sticky label on the side of the case needs to be lifted and then the bottom half of the case will come off.

The bottom board can be seperated from the top board quite easily ( pulls apart on a pin/socket ) and will give you access to the cables you need to repair.

Hope this helps

[Richard Law]

Thanks Rich, your a star, i now forgive you for cancelling my bid on fleebay on your lipo's

[Richard Law]

Taken the 4 fan screws out & the label of the side and still no luck. the fan screws only go into the fins on the heatsink!
maybe its been glued in the past?

[Richard Law]

It'd been glued!! Leatherman sorted the matter!

[Rich D]

Originally Posted by Scoobylaw

Thanks Rich, your a star, i now forgive you for cancelling my bid on fleebay on your lipo's

haha no worries pal. Glue i didnt forsee !

Originally Posted by Scoobylaw

Taken the 4 fan screws out & the label of the side and still no luck. the fan screws only go into the fins on the heatsink!
maybe its been glued in the past?

Yes but you need to seperate the fan and bottom board from the heatsink and FETS on the top board as you will most likely of discovered by now