|
||
|
 |
|
||||||||||||||||||
|
#1
16-03-2010
|
||||
|
||||
pinion spur on xx
 hi guys im getting my xx running again was wondering if any 1 has any ideas on what pinion & spur to run il be using an ezrun 5.5t 6000kv motorthanks guys 
|
|
#2
16-03-2010
|
|||
|
|||
|
Craig, with that kind of motor mate I dont think it will matter, it will be in pieces inside two minutes.....
A 5.5 in a "current" 2wd is insane, in an older model even worse, and that is before you even stop to consider the small size track you will run on, you want somthing more like an 8.5 to be honest.
__________________
 ORCA - LC RACING - RUDDOG PRODUCTS - JCONCEPTS - ALPHA PLUS - TEKIN RACING - ULTRAPOWER AVID R/C - VAMPIRE RACING - EXOTEK RACING - LUNSFORD RACING - X-FACTORY - TUNING HAUS - WTF AME - RAGE R/C - REVOLUTION DESIGN RACING PRODUCTS - McKUNE DESIGN - TEAM AZARASHI X-PARTZ - PHAT BODIES - RACERS EDGE - RM2 - DIRT RACING PRODUCTS - DMS INSERTZ TKR GRAPHICS - BF MATERIALS - BATAN - DMS PARTZ - TEAM AJ Tel : (01923) 816636
|
|
#3
16-03-2010
|
|||
|
|||
|
Darren speaks the truth there!
I remember the look on his face when i said i would run a 4.5 at parmitters... I did and it ran hot, near impossible to gear correctly and makes controlling the car very very difficult. Think about a 10.5 may be more practicle. Back when i still had chance to run up there i would make the top 10 quite regulary in touring cars with a 19T motor and cheap cells. Same rings true in buggy.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Team Losi Racing
Linear Mode
