|
#1
|
|||
|
|||
![]()
hi i got a b4 off here rtr 5.5 turn motor with 81 spur gear and 20 pinion it been run fine for a while and today i tested it as it was setup and after about 8 mins it was over heating ,but i can normal use all my battery till it goes flat. any help would be good
i am using a ezrun esc and 5.5 turn motor Last edited by stampede vxlboy; 28-10-2009 at 04:54 PM. |
#2
|
||||
|
||||
![]() Quote:
Why do you have to run it until flat? Recomended storage for lipo's is 3/4 charged I think.
__________________
|
#3
|
||||
|
||||
![]()
Sorry. Ignore previous post - I see you've edited it!
__________________
|
#4
|
|||
|
|||
![]()
its been fine up untill now just keeped cutting out and no signal
|
#5
|
||||
|
||||
![]()
Were you doing anything differently? I know you've mentioned before you run it through wet grass. maybe the grass grew taller, and thus has increased drag?
Have you changed the brake settings? I know you mentioned before that you were having problems with the brake settings on the ESC, when the brake settings are set higher they normally increase the load on the ESC and can result in higher temperatures. Have you considered maybe venting the ESC with small holes in the shell? Sometimes a good idea is to cut a decent size hole, and then put some fine mesh across; this stops debris entering the chassis. Julius. |
#6
|
|||
|
|||
![]()
yes i changed the brakes to full power no drag on it and the back end lock up when you hit the brakes. but apart from that just solder a wire that had come off that it ,but the grass was a bit wet and a bit of mud but the car was still ripping the grass up
![]() |
#7
|
|||
|
|||
![]()
Surely a 5.5T is too much for a EZ run - probably themalling
|
#8
|
||||
|
||||
![]()
5.5 in a B4 is going to be a bit much too..
Thought you were selling it???? ![]() |
#9
|
||||
|
||||
![]()
id say too hot a motor , is its this speedo http://www.hobbycity.com/hobbycity/s...verse_programm.)? you only got 60 amps, its try running for 5 mins , it will get hotter the longer you run
__________________
MBModels - Schumacher Racing - Vapextech.co.uk - MRT - Savox - SMD |
#10
|
|||
|
|||
![]()
its been fine till today that a turnigy esc not ezrun but looks the same its up forsale with loads of parts a bargin
|
#11
|
||||
|
||||
![]() Quote:
![]() You chop and change so much. Stick with a car a develop it and learn about it and the electrics. I've run the same motor and ESCs etc. all summer season. I know exactly what to look out for and so on. Get a 7.5 or 8.5 for the B4 (if you are keeping it) |
#12
|
|||
|
|||
![]()
its up forsale need the cash
|
#13
|
||||
|
||||
![]()
Hang on so you are still running a car that's up for sale....
![]() Sorry, but when I put something up for sale I don't use it so that's condition isnt' compromised etc. and the seller knows what they are getting. If it's up for sale, clean it and put it to one side etc. |
#14
|
|||
|
|||
![]()
i tested it for the last time today its all been cleaned etc take a look there loads of spares and gears with it etc
|
#15
|
||||
|
||||
![]()
Should we be advising people not to purchase it then?
It sounds like you tamper with things too much. I don't think it's good morals to sell something that could potentially have a problem. If I were you; you should either attempt to solve the problem, or list it as temperamental. Julius. |
#16
|
|||
|
|||
![]()
it runs like a dream it just over heated that all pal. i had sorted it out ok with you
|
#17
|
||||
|
||||
![]() Quote:
![]() |
#18
|
|||
|
|||
![]()
its all been done ready to race up forsale bargin with all the stuff loads
![]() ![]() |
#19
|
|||
|
|||
![]()
back on topic
i run a 8.5 in my cat sx on 54/85 gearing, hope that helps
__________________
4wd - X4TE 2wd - X2C (Mad Rat passed down to son!) Ansmann Racing UK RIP - MicroTech Racing Trader Feedback |
#20
|
|||
|
|||
![]()
your funny that good gearing nothink to do with a b4 pal
|
![]() |
Thread Tools | |
Display Modes | |
|
|