|
#1
|
||||
|
||||
![]()
OK, i have the ninja.
Just come to fit the collet and flywheel... the collet will only go as far as the thread for the nut. is it really a case of brute force to get it to the end of the shaft? and then brute force to get the flywheel over the collet? |
#2
|
||||
|
||||
![]()
Its not unusual for it to be a little tight.
The easiest way to get it over is to use a small flat head (blade) screwdriver in the collet split, twist and move down. THis willl open it a little. The flywheel should then drop over this. |
![]() |
Thread Tools | |
Display Modes | |
|
|