Neat install of Nosram Speedo in 501x

[tenoracer 22]

Hi , I am wanting to install a ISTC Nosram brushless speedo in my 501 x . I have a low profile ko servo and a 3001 spektrum receiver. my problem is the height of the speedo with fan and the desire to keep wires short and super neat!! ( Its a bit of an obsession to be honest!!!!) Any advice or better still pics would be appreciated . Cheers, Phil

[Patpop01]

http://www.oople.com/forums/showthread.php?t=18900

I guess the LRP TC Spec is about the same as you speedo.

Have a look how I did it and you might get some ideas. I have a carbon plate on which I tape my speedo and it is attached to the main chassis by just one screw. Just undo the screw and you get great access to the motor mount screws.

I did some minor rewiring (brushless measurement wire together with the power wires) but my electrics setup hasn't changed since.

Good luck....