|
#1
|
|||
|
|||
![]()
Hi
has any one got a good set up for worksop for a cr2 ? thanks Richard |
#2
|
||||
|
||||
![]()
This is what I ran at the BNWO - the car was fast but I didn't have much luck in 2wd
![]() front: Mini Pin Yellow Green spring - 32,5wt - #56 - 1mm limiter Middle wishbone Outer tower Camber link 3-B, 2 washers 10gr of lead in nose rear: Mini Pin Yellow Red spring - 30wt - #56 - 0mm limiters 2 inside on tower Inner on wishbone Camber link 3-C, 3 washers Wheel base medium 0° anti-squat wing low, VLA front and rear long Full lead piece under lipo 20g lead between lipos and motor Lead under motor Lead between back of motor and gearbox -- try get the fr/rr weight split around 34/66 std CR rack no washers under ball studs 24/78 tooth on the 7.5 G
__________________
Graham North http://www.atomic-carbon.co.uk https://www.facebook.com/atomiccarbon https://www.facebook.com/nortechracing |
#3
|
|||
|
|||
![]()
My car was pretty good also-though I made too many mistakes...
Front: 37.5wt oil, black spring, red ghea pistons, no limiters Short VLA, middle camber link 1 washer, Inside on caster block Middle hole on wishbone, middle on a/c xd tower Rear: Long wheelbase (safer) medium (Faster), 32.5 oil ghea red pistons, pink spring, no limiters Long VLA, Inside on top tower, middle on wishbone. 2nd hole out on top row camber link, 2nd hole out on middle of hub, 2 washers ( I think ) Std cr steering. 27/78 with Atomic idler mod, losi 7.5 Front wing / aurora rear wing. 2 deg anti/squat Ghea fr bulkhead / Rudebits battery straps and under motor weight / lead under the battery approx 1850g.
__________________
PR-Racing UK Insideline-Racing Absima Last edited by Freakypen; 05-02-2010 at 08:12 PM. Reason: forgot stuff |
![]() |
Thread Tools | |
Display Modes | |
|
|