|
||
|
 |
|
||||||||||||||||||
|
#1
19-03-2009
|
||||
|
||||
x6 squared chassis
Just about to build my x6 and noticed that the front 2 cell locators
"where they are filled in " are all sort of cracked  and there is a very small hole through to the other side.is this the norm.    steve
__________________
When I die, I want to go peacefully like my Grandfather did, in his sleep -- not screaming, like the passengers in his car. 
Last edited by big air; 19-03-2009 at 11:17 AM. Reason: pics added 
|
|
#2
19-03-2009
|
||||
|
||||
|
I would say thats not normal, contact the shop were you got it, or I'm sure Darren will be along really soon,might be better to see the pics,
__________________
Mattys the driver,my names carl
|
|
#3
19-03-2009
|
|||
|
|||
|
The area of the two cell slots is VERY thin at the shallowest part but it should NOT have a hole. This can occur occasionally if the graphite does not fully flow through the mold and we have only seen this on one chassis so far (happened to be one we had sent to Hong Kong!!!) from here in the UK.
At the end of the day the hole is NOT right, but it will not effect performance, durability or stength in any way (since the box section around the two cell slot is what provides the core strength in that area, BUT if you wish for us to swap it over for you then please just pop it back and we will get it exchanged by return of post immediatley. Darren
__________________
 ORCA - LC RACING - RUDDOG PRODUCTS - JCONCEPTS - ALPHA PLUS - TEKIN RACING - ULTRAPOWER AVID R/C - VAMPIRE RACING - EXOTEK RACING - LUNSFORD RACING - X-FACTORY - TUNING HAUS - WTF AME - RAGE R/C - REVOLUTION DESIGN RACING PRODUCTS - McKUNE DESIGN - TEAM AZARASHI X-PARTZ - PHAT BODIES - RACERS EDGE - RM2 - DIRT RACING PRODUCTS - DMS INSERTZ TKR GRAPHICS - BF MATERIALS - BATAN - DMS PARTZ - TEAM AJ Tel : (01923) 816636
|
 |
| Thread Tools | |
| Display Modes | |
|
|
X-Factory
Linear Mode
