b4grub screw size

[reg]

hi there,could some one just let me know what size hex driver is needed for the little pesky grub screwsthat hold the hinge pins,
thanks
mark

[Mike Hudson]

.050"

[reg]

Thanks Mike,i had a brain wave and looked in the instructions,
has anyone replaced the screws with eather metric or just better quality ones,if so where did you get them,
mark

[Bungleaio]

I got the Nortech full kit for my 44, it was around £30 I think. There's some discussion and photos here http://www.oople.com/forums/showthread.php?t=8916

Most of the screws will be the same size. Alternatively I've bought metric screws from www.stagonset.co.uk and I was really pleased with then, I should imagine their imperial ones will be fine too.