Gear box housings

[cmgreen]

Any one know where i can get the front and rear gear box housings from?
Are they the same as tc3?

[Mike Hudson]

there the tc3 ones but may need a small bit milled off the bottom half of the casing to fit the chassis give dms-racing a call

[Chris Doughty]

I am not sure they are direct TC3 'boxes

I think the BJ4 ones are TC3 cases with bits milled off them to fit the BJ4

[Richard Lowe]

Yep Chris is right, the bottoms have been machined to fit the chassis - the tops are unmodified though and a direct fit.

You'll need to get them either through a model shop with an account with SMD or directly from JC, [email protected]

[cmgreen]

Thanks Guys!!