|
||
|
 |
|
||||||||||||||||||
|
#1
27-12-2008
|
||||
|
||||
Allen and Nut drivers for zx-5
Hi folks and hope everyone had a great crimbo
 Iv just ordered myself a titanium screw set for my zx-5 should be here just after new year, now i need some drivers to fit the hex heads on the kit! im hopefully going down later today to get some and also some nut drivers!! Can anyone advise me on what sizes to get for the zx-5, both for Allen drivers and Nut drivers... Cheers... Paul. 
|
|
#2
27-12-2008
|
||||
|
||||
|
all metric normally on the screw sets, mine was mainly 2mm but i also got 1.5mm and 2.5mm, recomend you get a 2.5 ball driver as well for the motor screws as this helps with motor installation. as for nut drivers, the wheel nuts are 7mm the shocktop nuts and ballstuds are 5.5mm. all drivers are available in the hudy range for 2 ranges of quality (both really good) or from any other tool companies from your local shop. as for online google up
dms, microtec or mkracing as all have an outstanding next day service and are very simlar on price 
__________________
Nathan Ralls HPI, Custom Blitz, www.piraterc.com mr-o foams woop woop racing officialy keeping team toe out inline 
|
|
#4
27-12-2008
|
|||
|
|||
|
http://asiaracing1.celeonet.fr/shop/...8b634a4f79c279
there you have all you ever need and sorry for advertising :/
|
|
#5
28-12-2008
|
||||
|
||||
|
Got an absolute bargain, my local Cromwell tools store!!
Bought 1.5, 2.0, 2.5mm ball end allen drivers for £1.43 each and 5.5mm and 7mm Nut spinners for less than £4 each also do full set for dirt cheap too!! I'v been on the spanners for over 10 years and have a lot of Cromwell/Kennedy stuff in my box...never let me down...this is top notch stuff for peanuts www.cromwell.co.uk
|
 |
| Thread Tools | |
| Display Modes | |
|
|
KYOSHO
Linear Mode
