|
#1
|
||||
|
||||
![]()
Out test driving my Catsx yesterday with a sintered 13.5 Novak GTB setup runnig kit standard spur and a 28 pinion ( I know it wasnt the correct gearing-I need 7-1 apparently) and after around 10mins the car stops. Fan still running but no steering etc..Sure the motor was a little hot but nothing that i havent seen before.After cooling down I ran it again and it lasted less than a minute. I tried this a couple of more times but it just kept shutting down. I have the Lipo cut off model but I tried fresh lipo's each time and still shutting down. Any idea's?
|
#2
|
||||
|
||||
![]()
If it thermals the servo still works
![]() G
__________________
Graham North http://www.atomic-carbon.co.uk https://www.facebook.com/atomiccarbon https://www.facebook.com/nortechracing |
#3
|
||||
|
||||
![]()
Ok that helps. Im running a spektrum reciever also and never had this happen before. I might swap that out with another and see if that changes anything. Cheers-Jason.
|
#4
|
||||
|
||||
![]()
Which receiver? Is it grey or semi transparent?
__________________
Nortech is ACE! |
#5
|
||||
|
||||
![]()
Grey. I have been running these receivers with all 3 of my GTBs for a while now. Its the first time this kind of thing has happened.
|
#6
|
||||
|
||||
![]()
Jim Dixon had some similair issues with a grey one recently at York, though with a Losi system not Novak.
It sounds like the Spektrum is shutting down either due to range (I have had this once when I was trying to run the aerial too low) or voltage. I'd stand the aerial right up and use a recevier cap for voltage protection and try again.
__________________
Nortech is ACE! |
#7
|
||||
|
||||
![]()
Wasn't Jim's problem the top (daughter) board in the RX hitting the bottom (main) board and shorting - resulting in it going flat out!!!
![]() ![]() But I agree with what Dan says about trying stuff. I ALWAYS run a cap now. G
__________________
Graham North http://www.atomic-carbon.co.uk https://www.facebook.com/atomiccarbon https://www.facebook.com/nortechracing |
#8
|
||||
|
||||
![]()
I appreciate your help guys. Thankyou.
![]() |
![]() |
Thread Tools | |
Display Modes | |
|
|