|
#1
|
|||
|
|||
![]()
hi fellow rc racers I have a Question ?
Is there a way of running our tarsponder with a spectrum dx2 2way channel we have heard there is or is it just a myth plz feed back would be great thanks |
#2
|
||||
|
||||
![]()
You can get a "Y cable" that splits one servo plug to two sockets, they are quite cheap.
|
#3
|
|||
|
|||
![]()
Doesn't the dx2 come with an sr300 rx?
That's (at least) got a bind port and I think an aux as well. You can plug the transponder into either. |
#4
|
||||
|
||||
![]()
a two channel receiver normally has three sockets, channel 1, 2, and battery input. Try the amb on the batt socket. The receiver will be getting its power from the ESC BEC circuit, so the batt input should be at 5-6V already.
__________________
-------------------------------------------------------------------------------------------------------------------
Team Yokomo - YZ-2CAL3 | YZ-2DTM3 | YZ-4SF2 | YZ-2T | YZ-2DTM Worlds | YZ-2DTM x2 | YRX-12 x2 ------------------------------------------------------------------------------------------------------------------- 10electric | Batley Buggy Club | YORCC | RHR | MB Models --------------------------------------------------------------------------------------------------------------- |
#5
|
|||
|
|||
![]()
hi thanks for the reply's will get the y lead and try that thanks again have a goon one
|
![]() |
Thread Tools | |
Display Modes | |
|
|