Orion R10 problem

[OneKiwi]

Right I have had the R10 in my 4wd without problems

Tested it in a 2wd worked well for a bit but now I get a fault

ESC switched ON, no motor function,
no audio tone.
Battery or connection problem.
Check battery and power connections, check
switch
Damaged switch

I have resoldered everything including the switch and RX cables, even swapped them out but still get the fault .
Tested with other sensor cables RX and motors still the same.

It calibrates but with no audio tone and the motor doesn't work

Has anyone had this and solved it? Or is this a bin job?

Thanks

[Neil Skull]

One last thing to check is your TX??

Might be worth opening the case and seeing if a fet has a blown, normally easy to spot and will give you a definite answer.

FYI we found that most ESC that fail occur when re-fitting into a new car. Replacing wires that are cut too short is not ideal, even for the most experienced solderer you can cause some small heat damage.

I tend to keep my ESC in my cars till they die or sell with the model!

[OneKiwi]

Thanks
I have tested it with 3 different RX and they all have the same result.

Ill have a look at the insides of the esc as well.

[K-Brewer]

have you tried with no sensor cable connected to motor?