|
#1
|
||||
|
||||
![]()
My ezrun 60a esc fan stopped working so I put a new one in and that doesn't work so tried another 3 new ones and all don't work so I'm guessing the esc fan connector is bust on the esc side,
The fans are only 5v and I run 7.2v 2s cells, they read 8.4v when fully charged obviously. Where is the best place to get power from for my fan. Thanks for any replies.
__________________
racer for life http://www.youtube.com/user/dooronron69 https://www.facebook.com/pages/Torba...44601622232368 www.actionmodelcentre.co.uk www.rcmodelimports.co.uk R.I.P www.gpmracing.com.hk my feedback: http://www.oople.com/forums/showthread.php?t=69066 |
#2
|
||||
|
||||
![]()
Hi there,this happened to me and all i do is connect mine to the reciever using a old servo wire if you have any spare channels in your receiver as it runs at 6v.Turns on with the car at the esc switch.Hope this helps..jon
|
#3
|
|||
|
|||
![]()
Yup, just plug it into the rx.
That's where my early ones went, before I got an esc with built in power. If you haven't got a spare channel, just get a servo y lead and piggy back it off something like your pt. |
#4
|
||||
|
||||
![]()
Thanks for the answers guys, spare rx plug it is, Thankyou
__________________
racer for life http://www.youtube.com/user/dooronron69 https://www.facebook.com/pages/Torba...44601622232368 www.actionmodelcentre.co.uk www.rcmodelimports.co.uk R.I.P www.gpmracing.com.hk my feedback: http://www.oople.com/forums/showthread.php?t=69066 |
![]() |
Thread Tools | |
Display Modes | |
|
|