sway bars on C4.2?

[ste_lazzaro]

This is mainly for Centro/CML pals..
No provisions were designed to allow installation of rear swaybars (or anti-roll bars if you prefer) on the C4.2.
Why is that? Easy to say "there is no need", but most of the competitors have such provisions, and more than a few guys are actually using swaybars.

[Lee24h]

Originally Posted by ste_lazzaro

This is mainly for Centro/CML pals..
No provisions were designed to allow installation of rear swaybars (or anti-roll bars if you prefer) on the C4.2.
Why is that? Easy to say "there is no need", but most of the competitors have such provisions, and more than a few guys are actually using swaybars.

Im not a cml/designer but it can be done as long as you confident with a tap and a drill
Mark out and dot two equally spaced holes then tap them m3
Use the xray rear roll bar holders of a t3 and file the bulkhead contour in the back of it
Then use a b4 rear roll bar and go from there
The end result can look very neat
As for why its not included or has provisions for is probally due to a lack of the cml factory drivers using them