|
#1
|
||||
|
||||
![]()
Time to start clearing out some bits, so I'll start first with some motors
First is a Speed Passion 6.5, bought new by me and used very little (I think it was either 1 or 2 meetings only) Has the most minor of marks from being used in a 2wd buggy. So in all a really good motor, close to new £25 posted Second is a Trinity/Epic Nemesis 6.5t. Good working order, noting the following-Minor marks to can from being in a 2wd buggy, minor piece of plastic trim has come away where the sensor plugs in (arrowed in photo). All cosmetic, motor works fine. SOLD Thirdly Novak Velocity 5.5r, very fast motor in good working order, however as shown in the photos the sensor lead has had the plug replaced. £18 posted Fourth up is GM 10.5t motor, again minor marks to the can from 2wd buggy running. NEEDS SENSOR BOARD! My son ran this all summer in sensorless mode without issue, £12 posted Lastly is a job lot of the early generation LRP/Nosram/Reedy motors. Sold as seen for spares or repairs, so no guarantee, but from memory: 1xLRP 4* (approx equivalent 5.5 -6.5t) with 12.3mm sintered rotor believed to be fully working. 1x LRP 4* bonded rotor, again I think this works. 1x Nosram Storm Evolution 10.5 with 12.3mm Sintered rotor, genuinely can't remember if this was one with a sensor problem or if it worked fine?? 1x Reedy Neo1, I think it is a 3* (approx 6.5-7.5t equivalent), definitely has a sensor problem. The final Nosram can in the photo is unworking and just for spares along with the other rotors bearings etc shown at the front. £20 posted for the whole lot, as even 1 sintered rotor would have cost over that and I think they may well be compatible with later models??
__________________
Last edited by Oscar; 14-10-2013 at 08:12 PM. |
Thread Tools | |
Display Modes | |
|
|