|
||
|
 |
|
||||||||||||||||||
|
#1
19-07-2008
|
||||
|
||||
How to change KO 2123 servo case?
Want to change the case but can't figure out how to get the middle part of the case off? I know this has been asked before but have no idea where the threads are.
Thanks Mike.
__________________
Custom MG-Racing Associated DMS 
|
|
#2
19-07-2008
|
||||
|
||||
|
Sledge hammer?
__________________
Matt Myers Team Associated b4 Team Associated b44
|
|
#4
20-07-2008
|
||||
|
||||
|
Quote:
 
__________________
Custom MG-Racing Associated DMS
|
|
#5
20-07-2008
|
||||
|
||||
|
Screw driver i supose try to free the inside off the case carefully.
A
__________________
Ashley Williams I always thought by 2013 we would have flying cars, but we have got blankets with sleeves!
|
|
#7
02-08-2008
|
||||
|
||||
|
have just done this myself as needed a new case for mine. there are 2 screws inside which make the change very difficult. i personally prized the motors section out very slowly which then gave me access to the screws on the other side but with hindsight i would of desoldered the 3 legs of the rotory switch first as this would of made the whole opperation a lot easier as then you can take the motor and board out easily and get to the 2 mentioned screws. if ya have any questions feel free to pm me
__________________
Nathan Ralls HPI, Custom Blitz, www.piraterc.com mr-o foams woop woop racing officialy keeping team toe out inline 
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
