K1 not fitting in BRCA Box

[steel]

hi ive just fitted the 10 degree alloy pivot blocks on my k1 with 2m of track washers front and back, ive just tried to put it in a box 250mm wide and the nuts seem to be catching on the side of the box it will go in with excessive force but then i cant pull it out im just wondering if i have done anything wrong.

thanks in advance

heres a pic

http://i1313.photobucket.com/albums/...ps0edf846c.jpg

[mark christopher]

kit is only 1mm front track washers and as far as im aware thats what the team run.
simple answer if its too wide take some washers out!

[steel]

hmm i wonder how mossy is fitting his in the box as im going off his setup and apparently hes ran 2m track

[Andrew Twigger]

Simon's setup uses 1mm track width spacers at the front.

[steel]

http://www.petitrc.com/setup/schumac...SetupSheet.pdf

:S have i miss read this or am i right haha

[Andrew Twigger]

1) The setup sheet you're copying wasn't a BRCA event
2) His latest setups use 1mm

[steel]

ahh ok

thanks

[dibble34]

I have 2mm washers on the front of mine with alloy blocks and it fits fine. Ran it at last regional.

[MattW]

2mm on the front of a K1 will be very wide. It was fairly wide on the SX series, and the K1 bulkheads are wider.