|
#1
|
|||
|
|||
![]()
For reasons I'll not explain
![]() Cheers ![]() Rich |
#2
|
||||
|
||||
![]()
You probably wouldn't feel that much performance gain, but run time would increase massively. The cut off prevents the lipos from dropping below 0.3v per cell, but make sure it is a lipo safety cutoff like this http://www.jemodels.com/electric-mod...FczHtAodJ2YAaQ
To charge lipos, almost all are rated at 1c. That means for a 5000mah battery = 5.0a, 6100mah = 6.1a. |
#3
|
|||
|
|||
![]()
Buggy - did you mean 3.0v per cell? At 0.3v per cell wouldn't the LiPo be trashed? That's what all the LiPo manufacturers tell us - 3.0v per cell absolute minimum, 3.2v per cell preferred.
|
#4
|
||||
|
||||
![]() Quote:
__________________
if its got an electric motor you can afford it if its got an engine you can barely afford it if its got a pair of boobs you cannot afford it |
#5
|
||||
|
||||
![]()
Yes, sorry got my 3 and 0 mixed up.
|
#6
|
||||
|
||||
![]()
Run with the lipo, the weight change will interesting, extra bit of power, longer run time etc, you would not want to run for more than 10 minutes or your motor may become abit warm, but you can see how you go and adapt.
Make sure you have a lipo dedicated charger, always double check the settings if you are mixing batteries, a reasonable lipo charger will give you a voltage reading and tell you whats been put back in, if you are careful you will not go anywhere near 3.2V/cell. Topup & run - perfect |
#7
|
|||
|
|||
![]()
Thanks for the advice, I already have a decent charger so no worries there. Any tips on where to find a cheap low voltage fut off? I've seen plenty of alarms but would prefer a cut off so it's foolproof!
Rich |
#8
|
||||
|
||||
![]()
Only ever seen the novak one, but for that price you could get a cheap speedo with the cutoff built in..
|
#9
|
||||
|
||||
![]()
It ill be fine just be careful not to go below 3.0v a cell
Go for 5mins at first then youll get use to what time you can run for |
![]() |
Thread Tools | |
Display Modes | |
|
|