|
||
|
 |
|
||||||||||||||||||
|
#1
08-10-2012
|
||||
|
||||
ESC ????
HI
Just bought a car a car off the bay and its coming with a CX-11HF esc. Im going to run my cyclone anyway but just wondered if any one knows anything about the CX only out of interest
__________________
www.noelracing.co.uk www.teamxtreme.co.uk www.the-pred.co.ukhttp://www.moorefinance.com/ http://www.oople.com/forums/showthread.php?t=122610 
|
|
#2
08-10-2012
|
|||
|
|||
|
From what I recall the cxii is a good esc from ko propo. They released several speedos in the cx series.
I'm sure the cyclone is an excellent choice though! You may want to ask Bormac as he probably knows more. Obviously it depends what setup you use or if you want to be era specific ( e.g. Lrp ICS in a pavidis '95)
|
|
#3
08-10-2012
|
||||
|
||||
|
Yes i did think that i remember getting the ICS first gigh end speedo !!!! got so excited installed it all connected it the wrong way round and it went pop gutted !!!!!
im unsure what to do about cells !!! any ideas
__________________
www.noelracing.co.uk www.teamxtreme.co.uk www.the-pred.co.ukhttp://www.moorefinance.com/ http://www.oople.com/forums/showthread.php?t=122610
|
|
#4
08-10-2012
|
|||
|
|||
|
Yeah the ICS series is great!
Either you can go vintage with scrc Sanyo ...or look for Voltz nimh saddle. You can find them on cml or eBay. Lipos are not very straight forward to install. You need to check the dimensions and how the saddle posts go. You could alternative strap them down using battery tape. Moreover lipos may affect weight distribution so some thought may be required here. I would just go for an nimh setup.
|
|
#5
08-10-2012
|
||||
|
||||
|
Yes im looking on the bay but cant seem to find them ?
__________________
www.noelracing.co.uk www.teamxtreme.co.uk www.the-pred.co.ukhttp://www.moorefinance.com/ http://www.oople.com/forums/showthread.php?t=122610
|
|
#6
08-10-2012
|
|||
|
|||
|
Look at this on eBay:
Voltz 5300mAh 7.2v Saddle Pack with Tamiya Connector http://bit.ly/ONX7QD See cml aswell
|
|
#7
08-10-2012
|
||||
|
||||
|
thank you!!! dont think ill be able to do a tidy install with those though !!!
__________________
www.noelracing.co.uk www.teamxtreme.co.uk www.the-pred.co.ukhttp://www.moorefinance.com/ http://www.oople.com/forums/showthread.php?t=122610
|
|
#9
08-10-2012
|
||||
|
||||
|
how though ?? do you change wiring and connectors ??
__________________
www.noelracing.co.uk www.teamxtreme.co.uk www.the-pred.co.ukhttp://www.moorefinance.com/ http://www.oople.com/forums/showthread.php?t=122610
|
|
#10
09-10-2012
|
||||
|
||||
|
Ko Propo CX-II
I have a couple of these old esc's and while they look nice I think you'll be dissappointed in their performance.
While the CX-I and CX-III have some very impressive numbers (in regards to amp draw ability) you'll find the CX-II is no where near as capable as these and of handling mod motors. Definately wouldn't run one with Lipo's either. maybe ok with a stock or 540 silver can motor in my opinion. Novak's Cyclone esc's are far better than the CX-II.
__________________
Vintage R/C nut.  Reliving all the good old days of r/c from the 80's and early 90's. -Jason ***always on the hunt for vintage KO ESC's***
|
|
#12
09-10-2012
|
||||
|
||||
|
It's not to say you shouldn't have a go at the CX-II, just get ready for the puff of smoke when all goes wrong- LOL!
__________________
Vintage R/C nut. Reliving all the good old days of r/c from the 80's and early 90's. -Jason ***always on the hunt for vintage KO ESC's***
|
|
#13
09-10-2012
|
||||
|
||||
|
ill defiantly be using the cyclone
__________________
www.noelracing.co.uk www.teamxtreme.co.uk www.the-pred.co.ukhttp://www.moorefinance.com/ http://www.oople.com/forums/showthread.php?t=122610
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
