|
#1
|
||||
|
||||
![]()
Hi,
I have just finished my build and I have come across a problem. I am loosing signal about 10m away from me. I am guessing it is because of the cf. Does anyone know how to solve this and the tx/rx are etronix. Cheers, Sam
__________________
Sam Harris Serpent Spyder SRX-2 MM
|
#2
|
||||
|
||||
![]()
Better radio gear
|
#3
|
||||
|
||||
![]()
Is it the old Etronix?
__________________
Vega RB6 - Orion - Apex Models - JE Models - Cable ties
|
#4
|
||||
|
||||
![]()
the blue receiver.
__________________
Sam Harris Serpent Spyder SRX-2 MM
|
#5
|
||||
|
||||
![]()
Bring it down Sunday and we'll have a fiddle, I have a spare set of tx/rx mate.
Will give the car the once over too ![]()
__________________
Vega RB6 - Orion - Apex Models - JE Models - Cable ties
|
#6
|
||||
|
||||
![]()
Sam make sure the batteries in the tx are fully charged, those systems dont like going under 10v, mine used to do this around that voltage
__________________
A rc car is not just for christmas, it's for life
|
#7
|
||||
|
||||
![]()
check the aerial in the transmitter has got a break in the wire, someone i know had the same problem we put in a new aerial and the problem went away,
__________________
Mattys the driver,my names carl
|
#8
|
||||
|
||||
![]()
I will be down torch sunday and I will change the later on tonight. It worked fine in my x2c so it confused me.
thanks for the replies, Sam
__________________
Sam Harris Serpent Spyder SRX-2 MM
|
#10
|
||||
|
||||
![]()
Sorted cheers for the help, now off for 5 hours sleep!!
__________________
Sam Harris Serpent Spyder SRX-2 MM
|
#11
|
||||
|
||||
![]()
can't say it's the cf in the b44.1 as I don't run my aerial outside the car with futaba gear. it's just slid into a bit of heat shrink out the way and left in the car.
|
#12
|
|||
|
|||
![]()
Nothing to do with carbon
__________________
Gareth Hill Schumacher - Sanwa - LRP - Mb models |
![]() |
Thread Tools | |
Display Modes | |
|
|