|
||
|
 |
|
||||||||||||||||||
|
#1
28-08-2012
|
|||
|
|||
C4.1 LWB Chassis
C4.1 LWB chassis 10mm longer:
 
__________________
http://insidelineracing.co.uk 
|
|
#2
29-08-2012
|
||||
|
||||
|
What body are you meant to use with this?
how does it make the car drive compared to the original length chassis?
__________________
-------------------------------------------------------------------------------------------------------------------
Team Yokomo - YZ-2CAL3 | YZ-2DTM3 | YZ-4SF2 | YZ-2T | YZ-2DTM Worlds | YZ-2DTM x2 | YRX-12 x2 ------------------------------------------------------------------------------------------------------------------- 10electric | Batley Buggy Club | YORCC | RHR | MB Models ---------------------------------------------------------------------------------------------------------------
|
|
#3
29-08-2012
|
|||
|
|||
|
I'm using the finnisher shell as it's got the flat bit at the back
A normal shell fits a bit shit IMHO The longer chassis makes it easier to drive, more consistent as per the longer chassis on vega cars 
__________________
Gareth Hill Schumacher - Sanwa - LRP - Mb models
|
|
#4
30-08-2012
|
|||
|
|||
|
Tried this last week, makes the car a lot more predictable and smooths out the twitchy steering, basically does exactly what it says on the tin!
__________________
Team Losi Racing, Horizon Hobby TLR 22 5.0, TLR 22X-4, TLR 22-4, 22-4 2.0 Atomic Carbon S2, S44, Vega B4.1 Trader feedback: http://www.oople.com/forums/showthread.php?t=19374
|
|
#5
30-08-2012
|
|||
|
|||
|
Hay up Tom, glad you like the LWB chassis.....
Gaz, have you run it yet ? How about cell placement, did you move them forward or just try at the back and I am guessing this was at SP ? I found the small Lipo even better over bumps. (The kit shell fits, you just need to extend the front body clip hole a little forward) Tony
__________________
http://insidelineracing.co.uk
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Team Associated
Linear Mode
