|
||
|
 |
|
||||||||||||||||||
|
#1
23-08-2012
|
||||
|
||||
Remove one way bearings?
Anyone know how to remove / replace the one way bearings in a one way diff? Are they just pressed or would they be glued also?
It's a HotBodies D4 one way diff in question - I want the bearings the other way round so I can turn the gearbox upside down. Anyone know how it can be done - or even better, want to do it for me?  I don't have a vice or anything and I've tried some pliers on the bearings and that wasn't happening.
__________________
If your PM doesn't at first succeed - try, try again. I'll reply in the end, honest.  
|
|
#2
23-08-2012
|
||||
|
||||
|
ares was glued in the loctite, warmed it up with a soldering iron and taped it out with 2-3 sharp raps,
__________________
Mattys the driver,my names carl
|
|
#4
24-08-2012
|
||||
|
||||
|
no worries boss
__________________
Mattys the driver,my names carl
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
