|
#1
|
||||
|
||||
![]()
hello
Im looking to make a rc mini copper 1/10, 1/12 but don't know what chassis to make it on it has to fit a mini body shell of it's wheel base needs to be 210mm and it must fit hard case lipo's. i want to buy 2nd hand keep the cost down thanks alex |
#2
|
||||
|
||||
![]()
The Tamiya M03 or M05 can be 210mm wheelbase
__________________
Schumacher Speed Passion Futaba Support from: My Back Pocket Driver - 'Derek' Feedback Link : http://www.oople.com/forums/showthread.php?t=48311 |
#3
|
||||
|
||||
![]()
it needs to fit hard case lipo's
|
#4
|
||||
|
||||
![]()
I have seen a 1/12th scale Corrally running a Mini body
|
#5
|
|||
|
|||
![]()
Hi will fit m03 or m05 and will take hard case lipo as this is what i have in mine
|
#6
|
||||
|
||||
![]()
i have other lipo's that wont fit
|
#7
|
||||
|
||||
![]()
Some of the hongkong sellers do ronded case lipo's that will fit the M03/M05 I have used the Yeah Racing cells and they fit fine after a slight adjustment on the battery holders or if you have the squarer shape cells your can take a dremel to the chassis to make them fit, A bit extreme but I've seen it done.
|
#8
|
|||
|
|||
![]()
These lipo are a perfect fit for the M-Chassis and have great performance too.
http://www.pit-bitz.com/product_info...roducts_id=825
__________________
www.pit-bitz.com |
#9
|
||||
|
||||
![]()
I've just spent 100+ on lipos I don't want to spend more but thanks
It can be 2wd or 4wd I don't mind |
#10
|
||||
|
||||
![]()
what do people think about the corally mini assists and know where i can get one 2nd hand
thanks |
#11
|
||||
|
||||
![]()
The Mini Assassin is great, as long as you don't expect to fit mini size wheels on it, touring car size wheels only to fit over the suspension.
If your club is happy to let you run a 4wd mini, and you don't want to make any modifications to the car, then you want to look out for the proper 4wd minis, not a chopped up touring car. Look for the Xpress MRR2, Active Hobby A210SS or ABC Hobby Genetic. Avoid the Corally Mini Assassin and Xray T1M unless you are prepared to run touring car size wheels and a 1/12th Dodge Stratus body. Or just get an M03 or M05 and make a bigger hole through the chassis with a Dremel.
__________________
Visit my showroom |
#12
|
||||
|
||||
![]()
it's not to race it's for a little project over the summer to make a mini copper and make all the seats steering wheel ect so it dose not have to be good at racing i'll have a look for the cars that u said but dose any one know other cars
thanks |
![]() |
Thread Tools | |
Display Modes | |
|
|