|
#1
|
||||
|
||||
![]()
Running my SCT last night when car cuts out, with a SP citrix 10.5T brushless system
Found that the yellow wire had disconnected itself from the motor. Soldered the wire back on (+ checked that I hadn't bridged across any solder tabs), managed 1/2 lap and it cut out again. ESC was red hot so let it cool, tried to run it again and nothing. Tried recalibrating the esc but nothing Today I connected a different motor to the esc and nothing (esc got really hot though!) Connected the 105 motor to a different esc, it ran for 5 secs, smoked and then stopped. From this I can deduce that both the esc and motor are both dead, unless there is something else I could try?
__________________
www.wbmcc.com |
#2
|
||||
|
||||
![]()
I think that they are both dead, bot I have a nice short course system on eBay
http://item.mobileweb.ebay.co.uk/vie...id=91474505648
__________________
|
#3
|
||||
|
||||
![]()
Thats what I suspected.
Your brushless system looks nice - I notice the motor is rated at 3300 KV, is that equivilant to about 12T?
__________________
www.wbmcc.com |
#4
|
||||
|
||||
![]()
I had a 8.5 turn that was rated at 4000kv so I think that 3300kv is about 10 ish
__________________
|
#5
|
|||
|
|||
![]()
Shameless plug but I do have brand new Trackstar 100A Sensored ESC and used once 10.5bl in the for sale section £65 for both if you want them.
|
![]() |
Thread Tools | |
Display Modes | |
|
|