Go Back   oOple.com Forums > General > Electrics
Reload this Page Fusion Pro ESC
Register FAQ Members List Social Groups Calendar Search Today's Posts Mark Forums Read

Reply
 
Thread Tools Display Modes
  #1  
Old 25-05-2012
Brewskie Brewskie is offline
Member
  
Join Date: Apr 2012
Posts: 298
Default Fusion Pro ESC
Running as title says with 10.5t motor an heat wise it's getting around 100F after a 5 min race, have the ESC set up for hard acceleration but have power curve set to linear an not hard, does anyone have any experience with these settings as I'm pretty new to all this an ran a 9t ezrun before with overheated an the main shaft came out hence why I now run exceed but weary about over heating this motor if I mess with the settings. If anyone can shed a bit of light an give some advice it would be much appreciated
Reply With Quote
  #2  
Old 25-05-2012
MrMagoo MrMagoo is offline
Senior Member
  
Join Date: Oct 2010
Location: Southampton
Posts: 526
Default
Are you using drag brake?
__________________
Reply With Quote
  #3  
Old 25-05-2012
Brewskie Brewskie is offline
Member
  
Join Date: Apr 2012
Posts: 298
Default
30% I think mate
Reply With Quote
Reply

« Previous Thread | Next Thread »
Thread Tools
Display Modes
Linear Mode Linear Mode

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT. The time now is 09:03 PM.

Contact Us - oOple.com - Archive - Top

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
oOple.com