|
||
|
 |
|
||||||||||||||||||
|
#1
14-03-2012
|
|||
|
|||
would this body shell fit?
would this body shell fit an lrp s10 blast tx truggy? and what equipment would i need to cut the bodyshell
http://www.blacksmithproducts.co.uk/...asp?prod=41101
__________________
My youtube channel: RC World <Clicky! For rc tips,tricks reviews and bashing! New videos soon! SUbscribe rate and comment Keeping fast motors going fast! 
|
|
#2
14-03-2012
|
||||
|
||||
|
Don't know if it will fit.
To cut the shell you can do it in 2 ways. Lexan scissors / Curved Lexan scissors is one way. Personally for all the ones I do I score around them with a scalpel and then just fold it back on the score line and it snaps off. If you're not so handy with a knife though the scissors are probably your best bet ! http://www.youtube.com/watch?v=rH0JH1zrZDM Can't get youtube link to work directly despite numerous attempts, if a mod wants to correct it that would be ace so the video is imbedded in my post. Last edited by Col; 14-03-2012 at 08:18 PM. Reason: Added You Tube vid
|
|
#3
14-03-2012
|
|||
|
|||
|
There ya go..
__________________
 Robert Jaques, Schumacher Racing KC, K2. Team Associated SC5M "The Japanese Sniper" Team Autocare & Cycles
|
|
#4
14-03-2012
|
||||
|
||||
|
The easiest way to find out ifthe shell would fit your rc is measure you old shell as it gives you all the measurements on the link you posted of new shell
It can be possible to make other shells fit but depends on how much work needs doing on them to make them fit and if you have enough shell to play with to trim around
__________________
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
