my bosscat

[PLINIO]

position where it will be the lipo and ESC and receiver
120a and waterproff mtoniks esc
2.4 receiver
brusless motor

family photo

new materials

hub carries front and rear
all bearings
ceramic balls for differential
diff washer
diff output yokes
drives mouldings
all screws
wheels j.racing
all belts: 3 and 5mm kevlar

of schumacher cat sx2 I bought

3 pro trust bearing,rear and front diff, slipper
2 pro diff screw set: conical washers
2 roll bar set rear: to the front and rear

I need bodywork and spoiler
I'm sure I forget something, I will tell you
Thank you very much and sorry for my English writing
Greetings from Spain

[kaszal]

Hi, nice Bosscat!

I noticed you moved the battery pack forward.

Do you have some part numbers and photos of the Cat SX roll bars fitted to your Bosscat yet?

[PLINIO]

I have moved the battery forward to see how it works to be more level.
stabilizer bars I'm waiting to come to me.
U1954Pro - Thrust Bearing
U3380
Roll Bar Set; Rear - Cat SX set 3
I hope serve bosscat

U2573

Pro-Diff Screw Set )()(

[PLINIO]

failing to prepare for the posts for the car lipos already completed, new engine with esc 6.5 and 2.4 receiver.
as comment, belts, bearings, wheels, ball differential and more, all new. to the bodywork and in the absence of paint

The only change regarding how the battery was is that I have the more advanced (before was where the drive and receiver)
now is more stable and the weight is more focused

The following tuning is to put the address of the new schumacher bearings and wheel bearing prepare for hexagon
but go with the car is a lot minh and belts, bearings and differential endure to perfection, also I have the slipper not interpret much.
regards