|
#1
|
|||
|
|||
![]()
As per the title, was wondering if I could get away with this low profile servo in my Blitz as it'd allow me to run a bit of weight behind the servo. Just not sure if the 1251 is tough enough for this class of racing. Any comments?
|
#2
|
||||
|
||||
![]()
thay do have big wheel and take some hard hits, personally id not risk the smaller gears of the low profile servo. a bigger servo will also be heavier!
__________________
MBModels - Schumacher Racing - Vapextech.co.uk - MRT - Savox - SMD |
#3
|
|||
|
|||
![]()
A heavier servo for a 2wd is MUCH better,as all the weight is on the rear normally.
I'm running the savox 1257 in my B4.1, Improves the weight quite a bit. As for weight, you can attach it on top of the servo or even put it underneath the servo. Thanks.
__________________
Feedback. |
#4
|
||||
|
||||
![]()
powerwise I can say that a low profile Savox is enough, I'm running a 1251MG in an SC10, it's fast and accurate;
__________________
Ansmann ARE-2 - 5.5T C4.1 Centro - 7.5T X-Factory SCX-60 - 10.5T Hyper 9e - MMM |
#5
|
||||
|
||||
![]()
i run one in mine and no issues at all ! perfect !
![]() |
#6
|
|||
|
|||
![]()
Ta for the comments. I'm gonna give it a go then.
|
![]() |
Thread Tools | |
Display Modes | |
|
|