X2C Rear mount

[madmax]

Ive had this mount made for my X2C finished off today. i am hoping to run it this friday at ribble vally. i only have a bad set of scales but the part is arround 60g, in the pic is the plastic kit one the AR ally and the brass one.

[madmax]

here is a pic of it on the car

[jim76]

anychance of making the pictures bigger? they are a little hard to see, unless that is just my pc?!

[madmax]

here is some bigger pics

[Tom3012]

Had one of these a while ago, never felt the need for it though, however that was outdoors...

[Dave Dodd]

I would like to know if anyone could make a similar rear mount in alloy, that is also tall enough to bolt the gearbox to.. currently i have spacer tubes between the top of the rear mount and gearbox case to support it as i use a flat shock tower bolted to the front of the mount.. ?

[wes j.]

Me and Rob are working on some Dave. Just waiting for Rob to give me some measurements .

[Dave Dodd]

Originally Posted by wes j.

Me and Rob are working on some Dave. Just waiting for Rob to give me some measurements .

wicked..

[fastinfastout]

Originally Posted by madmax

here is some bigger pics

who did them for you?

[madmax]

The alloy one is an upgrade part from ansmann. The bras one was made by a friend of mine.


Ran the brass bunkhead last night and found that it is far to much on carpet as the high grip and the transisional weight makes the back of the car colaps in the mid part of the corner. I think it would work well on low grip and wet condisions. More testing soon.

[Dave Dodd]

Originally Posted by Dave Dodd

I would like to know if anyone could make a similar rear mount in alloy, that is also tall enough to bolt the gearbox to.. currently i have spacer tubes between the top of the rear mount and gearbox case to support it as i use a flat shock tower bolted to the front of the mount.. ?

here is a picture of what i mean :