SP v3.0 motors in x2c

[SamRCRacing]

is there a way of making the connectors fit in because they only fit in one way but i'd pefer it another way because of sensor wire.
Could you dremel the screw holder or something.

Thanks

Sam

[brooksy]

Ive got a sp v3 7.5 in mine with the sensor wire connected but it is a tight fit.

[SamRCRacing]

The connectors get in the way.

[benjy]

ive got one pritty much upsidedown in my monkey

[Tom3012]

I did a little dremel work with mine, ill post a pic tomorrow, still tight but fits

[SamRCRacing]

Okay thanks for your help.

[Tom3012]

Picture below, i only took a small amount off, basically just sanded the edge flat... Hope the pic is clear enough

[SamRCRacing]

Thanks mate, best get dremeling for MKGP

[Tom3012]

Just be careful, do it a small amount at a time, and try the motor fit each time

[SamRCRacing]

Okay will do

[madmax]

ive got the sp v3 7.5 fitted to mine with no modification to the chassis all i dit was fit the motor with the sensor wire at the top

[MILKY]

Hi Sam,it fits with no mods but only goes one way but gives full mesh for all pinions.
Come see me at taplow Sunday or next Friday.

Neil

[SamRCRacing]

I got it sorted without any mods for mk gp and didnt do that bad, ill be there sunday.Are you running you x2c?

[Danny McGee]

Originally Posted by SamRCRacing

The connectors get in the way.

I just trimmed the chassis a bit. Works fine for me

[MILKY]

Hi Sam. Yes will be there on Sunday with the x2c. See you then.