|
||
|
 |
|
||||||||||||||||||
|
#1
27-09-2011
|
||||
|
||||
ez run esc
im using the ezrun v2 esc wit the turnigy motor but it will go for a bit the will stop with the red and green lights flashing togher when i pull the stick forward does any1 know what causes this help plzzz
|
|
#2
27-09-2011
|
||||
|
||||
|
isnt there nothing in the manual ant, have you tried doing the setup again via button, set mine up today, goes like sh*t off a shovel,
__________________
racer for life http://www.youtube.com/user/dooronron69 https://www.facebook.com/pages/Torba...44601622232368 www.actionmodelcentre.co.uk www.rcmodelimports.co.uk R.I.P www.gpmracing.com.hk my feedback: http://www.oople.com/forums/showthread.php?t=69066
|
|
#3
27-09-2011
|
||||
|
||||
|
Check what setting your lipo cutoff is on - should be 3v per cell, easier with the programming card if you have one/borrow one as the manual setup isn't the best
|
|
#4
28-09-2011
|
||||
|
||||
|
esc
im sure ive got the lvc turned off it only does it so often it will run then ill stop it then wount move with the green and red flashing at same time making a clicking noise then ill push car an it will go
 very odd
|
|
#5
28-09-2011
|
||||
|
||||
|
Try dropping a pinion size or two
|
|
#6
28-09-2011
|
|||
|
|||
|
If i remember right, this is a safety cut off following the loss of signal to the receiver.
Its particularly an issue with Etronix / code setups Loses signal once, cuts off until you switch off and on. Cannot switch the function off. Best to email hobbywing just to make sure. They answered my question within 24 hours
|
|
#7
28-09-2011
|
||||
|
||||
|
Found a site that might help - seems like a similar problem to how you describe, worth a look
http://www.rcknowhow.co.uk/2011/03/e...or-esc-review/
|
|
#8
29-09-2011
|
||||
|
||||
|
bang on
nice one it was the throttle link :P
|
|
#9
29-09-2011
|
||||
|
||||
|
throttle curve
curve i ment lol
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
