1s speeodo options...??

[tonymong]

hi all,

i am currently setting myself up to race in WGT and am on the look out for a speedo to do the job,

capable of 1s lipo but with a BEC output of 6.0v

ive seen a couple out there but surley there must be more of an option??

esp as they cost ££££...

so has anyone any suggestions on what i can use??

lrp sxx
nosram pearl
novak kinetic.....

many thanx

tony

[(off)roadrunner]

Try racers in exile They have a hobbywing. 1s speedo which has 6.0v bec and some very good features for around £100 I believe

[RogerM]

I've got a couple of HobbyWing 1S ESCs and they are fantastic. I've run them in pan cars with 13.5 through to 4wd off-road with a 5.5 in and they have handled it all with ease!

Click my sig for Racers In Exile and a direct link to the HobbyWing ESCs

[Chequered Flag Racing]

used Tekin RS (not Pro) can be found for around £75 or new for £129

Hobbywing Xtreme Stock (2s) under £60 new. Will run 1s but you need a booster which range from £6 to £35. I'll show you how to wire it with booster. It'll run the same 1s software as Catchpole's.

Mamba Max Pro 1s. Booster required (check o0ple sales for esc)

You'd also need a programmer and or PC trackside though for all the above.

KISS
Stock Spec V2, either Norsram or the LRP SXX. Less options in tuning but much easier to setup. Used around £100. No booster needed.

Ask at the club next time your in

[cigbunt]

Originally Posted by Chequered Flag Racing

Hobbywing Extreme Stock (2s) under £60 new.

where do you get it for 60 from?

[Chequered Flag Racing]

Originally Posted by cigbunt

where do you get it for 60 from?

here

[Chequered Flag Racing]

Wiring the Tekin for 1s

using receiver pack
http://www.rctech.net/forum/attachme...-schematic.jpg

using booster
http://www.rctech.net/forum/attachme...-2s-wiring.jpg



Wiring the HW Xtreme Stock for 1s posted on racechat
http://rcracechat.com/vb/attachment....5&d=1300297665
In the pic you can see the Hobbywing Xtreme Stock and RC Dynamics booster. The rx lead from the esc has the red lead removed and tiewraped out of the way. The booster rx plug has the red lead removed and inserted into the esc rx plug. Both the booster and esc plug need to be in the receiver and both units need turning on to be able to drive the model. To use the programming box the modified esc rx plug needs to be used in the programmer like normal but both switches must be turned on.

[RogerM]

Everything is accessable via the LCD programming card for the HobbyWing AND if you keep the firmware to a non-turbo version via the button on the switch!!

I've run my 1S on a single cell in a Mardave with NO booster or Rx pack and a brushless servo (hungry) without any hint of a problem!!
So if you want to keep is simple to start with then have nearly unlimited tuning options later go for the HobbyWing!

[Chequered Flag Racing]

Originally Posted by RogerM

I've run my 1S on a single cell in a Mardave with NO booster or Rx pack and a brushless servo (hungry) without any hint of a problem!!

That's because the 1s has a booster built in

The Xtreme Stock needs a booster though.