|
#1
|
||||
|
||||
![]()
What pinion should i start off with please in a Lazer Zx5FS using a speed Passion 2 LPF ESC and Speed Passion 7.5 motor. For astro
|
#2
|
||||
|
||||
![]()
21T or 22T if it's a short or rather long track
|
#3
|
||||
|
||||
![]()
I ran the following gearings when I was running SP motors, gearing on my current Orion motors is basically the same (note this is for open astro / multi-surface tracks, in brackets for smaller indoor tracks) .
5.5 = 20 or 21 (19 on very small tracks) 6.5 = 23 or 24 (21 on very small tracks 7.5 = 26 or 27 (25 on very small tracks) I hope that helps |
#4
|
||||
|
||||
![]()
I run a 25 or 26 depending on track type with an Orion 8.5vst which is equivalent to most 7.5t motors.
|
#5
|
|||
|
|||
![]()
Reading Roger's setups I ask myself: am I under-geared? I'm having a 22 installed on a 10.5, running mainly on mid sized tracks.
What do you guys think, is it safe to go for a 24 pinion? |
#6
|
||||
|
||||
![]() Quote:
Try a 25 or 26T for starters and see how it feels. I used to run a 21T on a 5.5T motor to tame it a bit so it sounds a bit low. Assume your running a kit spur gear. |
#7
|
||||
|
||||
![]()
I have a orion 6.5 and am running a 17 on the kit spur, running on a small indoor track. After reading these comments i may go up few teath
![]() |
![]() |
Thread Tools | |
Display Modes | |
|
|