bind ???

[markymark6183]

on my reciver it says bind on it !! what do you plug into it ?? out of the box its got a plug in it with a looped wire can someone just explain do i leave it the or plug in the steering servo in ??

thanks guys

[Whiskers]

That is there so you can bind the reciver to the transmitter but after you have done it make sure that you take it out otherwise next time you turn it on it will go back into bind mode and you will lose the connection between you car and transmitter. HTH

[markymark6183]

Now I understand, but which channel shall I plug the steering servo into ? It's a 3 channel system !

[Whiskers]

Ch1 = steering
Ch2 = Throttle/speed control
Ch3 = Usually PT or cooling fan or powercap (if needed)

[markymark6183]

thats great so once the tx and rx have got signal take out the bind plug and put the steering one in ?

[4_cell_racer]

Originally Posted by markymark6183

thats great so once the tx and rx have got signal take out the bind plug and put the steering one in ?

Turn on your transmitter, then turn on your speed controller, the receiver might flicker for a second or 2 while it finds the signal from the transmitter, the light on the receiver should then turn solid (stops flickering) and your ready to go

The bind plug only normally needs to be used once (normally when you first install it into a RC car/buggy etc), the steering servo plug has it's own slot in the receiver so no need to unplug it