|
||
|
 |
|
||||||||||||||||||
|
#1
26-01-2011
|
||||
|
||||
White ball cups
Hi all
Over the last few years I've noticed a lot of drivers using these, Are they RPM ones? I need to replace the ones on my DB01 as they are a bit sloppy. Question is: Who does them and what matching ball joints do I need (if any)  fanx all
__________________
Answer RC SWorkz 35-3 SWorkz 350T SWorkz S12-2 Instagram: crazylthirteen Blogger: http://the-croucher.blogspot.co.uk/ 
|
|
#2
26-01-2011
|
||||
|
||||
|
The white ball cups are made by Losi, RPM and JConcepts but they don't fit the metric Tamiya ball studs so you need to get some HotBodies ones. They do two lengths and you need a pack of both to do the car. If you do a forum search there is a post with the part numbers for both packs
 I use Jconcepts cups but the they're a bit short for the standard rods. RPM do long and short shank cups so they would probably be the best bet.
__________________
Mark Dyson Clown
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
