|
||
|
 |
|
||||||||||||||||||
|
#1
21-12-2010
|
||||
|
||||
B44 ujs
Guys,
im currently using an RC10 B2 and need more rear end droop, and believe the answer lies with the B44. Ive measured my MIP dogbone section of my uj from tip of the cup to the tip of the ball and it comes to 60mm. Anyone know the lengths of the front and rear of the B44? Also the width of the ball. Thanks.
__________________
www.kamtec.co.uk www.fibre-lyte.co.uk answer-rc.com/uk/en/ Answer UK team driver Designer of the Lazer ZX/ZXR carbon fibre tub chassis Designer of the Lazer ZXRS 
|
|
#2
21-12-2010
|
||||
|
||||
|
Quote:
__________________
Gareth Stanton
|
|
#3
21-12-2010
|
||||
|
||||
|
B4 ujs are too long hence why im after lengths for a B44.
__________________
www.kamtec.co.uk www.fibre-lyte.co.uk answer-rc.com/uk/en/ Answer UK team driver Designer of the Lazer ZX/ZXR carbon fibre tub chassis Designer of the Lazer ZXRS
|
|
#4
21-12-2010
|
||||
|
||||
|
Quote:
__________________
Gareth Stanton
|
|
#5
21-12-2010
|
||||
|
||||
|
Ive had a B4 and sorry to say it but its crap. The older models were better designed and easier to setup and drive. If i do buy a new 2wd itll be the new Losi.
__________________
www.kamtec.co.uk www.fibre-lyte.co.uk answer-rc.com/uk/en/ Answer UK team driver Designer of the Lazer ZX/ZXR carbon fibre tub chassis Designer of the Lazer ZXRS
|
|
#6
21-12-2010
|
|||
|
|||
|
Quote:
 That made my day!
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Team Associated
Linear Mode
