losi8 with tekin 2250kv brandnew combo

[losi madness]

my tekin rx8 sytem 2250kv
. its like new the truggy and shell comes with loads of spares and the rx8 sytem comes with hotwires and 2 packs of 4s lipos 3000mha 35c . the sytem as been set up and that it . . these pics are old pics before i put the rx8 sytem in it

LOSI 8IGHT - T BRUSHLESS CONVERSION



Bought this second hand about 9 months ago as a project. It looked to be in good condition but on delivery it was sadly a little tired. Since then I've sent a fortune refurbshing it and could have bought a new one for what it cost me. To name a few things:

• New Hinge Pins
• New Hing Pin Braces
• New Hinge Pin Brace Covers
• New Suspension Arms Front and Rear
• Fully rebuilt Dampers
• New Wing
• New Protoform Body (This wasn't professionally sprayed so on close inspection there are a few flaws but from a distance or bashing it looks fine
• New Bearings all round
• New Diff Oil (7-10-5 Front-Centre-Rear)
• New Hubs / Carriers front and rear.
• New Servo Saver / Steering Linkage
• 1 New Diff Cup (Think the front one)

Also Included:

• Losi Brushless Conversion kit fitted - Original Plastic ESC mount cut off so I could bolt the Beast ESC to the Chassis.
• Carbon Suspension Mounts (Fitted)
• Several Sets of Suspension Springs
• Original Alloy Suspension Mounts
• Damper Rebuild Kit
• Comes fitted with Towerpro MG995 Steering Servo.
• Comes with Acoms Reciever (NO XTAL OR TRANSMITTER)
• Masses of Spares - Mainly the bits I've replaced but for a quick fix if you break something there should be enough to get you running again.
• When I bought it I was told there are enough bits to convert it back to nitro if you want. I cant verify this but there are a load of nitro parts (Fuel tank / disc brakes / throttle linkage / engine mounts / Spur gear etc).
• Original (tired) Body
• Instructions + Box
• Original Losi Wrench (not shown in the piccy's

.







there loads and loads of spares with it 2packs of 7.4v 25c x2 and 2 packs of 4s packs 3000mha 35c