glue/sticking graphite to graphite

[losixxx]

whats the best thing to glue graphite to graphite, chipped a corner off the rear of my xx4 chassis where the screw for the rear bumper goes and need to put it back together. tried superglue/tyre glue but no good, has anyone got any wonder stuff they can recommend??

[Gaz_Stanton]

epoxy resin probably as close to the orignal adhesive as you can get. Should do the job if not load bearing.

[lazerboy]

epoxy. (thats what cf is made from) Go spend some money and get the good stuff, it will have too much to possibly use, unless your making a boat, but it holds and bonds alot better than the hardware store stuff. lather it on, let it dry, and then sand it down. dont use a dremel, it will catch on fire.

[DCM]

from experience, no matter what you do, the corner will pop back off with a small knock, unless you can create a butt strap on the back, to bridge the two seperated parts. Expoxy will work, but make sure the ares is fully degreased first for most adhesion.

[super__dan]

What I do is spary activator on one part and a liberal amount of super glue on the other. Dress the excess across the seam and activate off.

[_sleigh_]

Buy a new chassis you tight arse

[lazerboy]

that's expensive.

[lazerboy]

and this is more fun.

[losixxx]

thanks fr the advice, as the chassis only has to do 3 more meetings i think i will give dan's option a go and just ignore mr sleigh's thoughts

thanks all

[jimmy]

I'm surprised Dan didn't try and hock you an X5squared as a fix!

[tyreman]

[bigred5765]

have a really good xx4 chassis for sale may be

[losixxx]

cheers carl, got 2 brand new plus a brand new rolling chassis sat here, just wanted to use the current chassis for the remainder of the year as more a lazy than tight arse

unless its about a fiver that is

[super__dan]

Originally Posted by jimmy

I'm surprised Dan didn't try and hock you an X5squared as a fix!

I'm more surprised now you come to mention it

[mark christopher]

Originally Posted by lazerboy

epoxy. (thats what cf is made from) Go spend some money and get the good stuff, it will have too much to possibly use, unless your making a boat, but it holds and bonds alot better than the hardware store stuff. lather it on, let it dry, and then sand it down. dont use a dremel, it will catch on fire.

id send it back to dremel then, they should not catch fire!!
and epoxy or carbon dont catch fire either

[Doomanic]

I've done three chassis there in the past 4 years.
Nothing will stick it properly, the best you can do is use shock shafts instead of pivot pins and a nut to hold the pin brace on.

[losixxx]

Originally Posted by Doomanic

I've done three chassis there in the past 4 years.
Nothing will stick it properly, the best you can do is use shock shafts instead of pivot pins and a nut to hold the pin brace on.

but your just an animal though