Spektrum Aerial Length

[GRIFF55]

I have just bought a spektrum module for my esprit 3, the question is, in the book it says you can shorten the reciever aerial to 3.6". Is this form the outside of the case and will this length give enough range for UK tracks??
Many thanks
Andy

[Body Paint]

I knew you would if I did LOL

I cut mine to 3.6" but have only used it once and I'm not totally sure if I was interferance free Sunday, but it's hard to tell in all that crap at Oswestry.

Don't go by what I say though, I am a newbie to Spektrum.

[k£v!n]

Ive cut mine to about 4" just to make sure its works on all tracks but i would imagine it would be fine at 3.6"

[GRIFF55]

Could i just coil most of the length up so only the aerial cap is poking out of the shell? Oh , and good luck at the euros'

[tyreman]

Andy

I've left mine at stock length and wrapped it round the base of the ariel holder. with just enough tube so the rubber cap touches the holder, and the ariel is completly inside the car, with no holes cut in the shell.

[losixxx]

ive cut 1 of my rx'ers and left 1 long, don't see any difference, and the cut to 3.6'' is important i wouldnt use 4'' or any other length apart from what they say, something to do with reception so im told.

[losixxx]

Originally Posted by Body Paint

I knew you would if I did LOL

I cut mine to 3.6" but have only used it once and I'm not totally sure if I was interferance free Sunday, but it's hard to tell in all that crap at Oswestry.

Don't go by what I say though, I am a newbie to Spektrum.

no interferance just your HRS kit's not compatable with the 3vc , how did you find it anyway, i know some of the top drivers don't use it because they say the notice a lag but to be honest at my level i don't!

[GRIFF55]

Thanks for the replies, all fitted and working.
One thing i have noticed is that sometimes when i punch the throttle, eg starting, the car doesn't go .
Anyone got any ideas as i travel far racing and dont want this happening sunday

[OldTimer]

I would get the power cap that plugs into the spectrum receiver part number is SPM1600

[Chrislong]

I have not trimmed my aerial, but what I have been doing is taping the wire to the chassis. It works at such high frequency that graphite causes no harm anyway, and it would be less harmless to tape it down than to cut the wire short.

[Chrislong]

Oh, the other thing, if you run LRP or a fariance of, then the BEC is garbage and Spektrum is weakened. Get some orange power and the BEC is plenty for Spektrum, even the first GTB's.

[k£v!n]

Originally Posted by OldTimer

I would get the power cap that plugs into the spectrum receiver part number is SPM1600

May sound like a silly questions, but what are the benefits of a power cap?

Thanks in advance!

[_sleigh_]

Originally Posted by OldTimer

I would get the power cap that plugs into the spectrum receiver part number is SPM1600

Do you or anyone else know the rating of this capacitor??????

[k£v!n]

Ive found some more information on their website -
http://www.spektrumrc.com/Products/D...ProdID=SPM1600

[losixxx]

phil

4700uf 10v

[_sleigh_]

Cheers Chris, I can see a trip to Maplin and make one tonight.

[losixxx]

Originally Posted by _sleigh_

Cheers Chris, I can see a trip to Maplin and make one tonight.

you going spektrum then

[_sleigh_]

No... not yet, just trying to fix the low BEC problem I was getting with my 40mHz receiver in my 2WD car.

Although I've not tried it with the replacement speedo I got a few months back, as it only happens about 4 minutes into a run (when the cells are starting to drop in voltage)..

[ashleyb4]

I had this problem with m old tranny in my xx4 so i got one of these spektrum power caps and it helped alot. But with my new tranny i havent got a problem.

A

[Body Paint]

PHIL:

You obviously didn't notice it happening in your 4wd aswell. I was marshalling your race and was thinking "how can he go that fast with interferance". It was similar to what was happening in your 2wd but not as bad.

CHRIS: Happy with the hrs stuff, all seems to work fine.