|
#1
|
||||
|
||||
![]()
Does this look correct? let me know if any problems or somethings not clear...
Ive NOT tried any other spur on the Durga so I'm going from what I've heard (96t wont fit - 87 AE will) http://www.oople.com/rc/photos/cars/501x/db01-501xworlds-gearchart.pdf might change it a little to make it look better, as long as its correct of course ![]() |
#2
|
|||
|
|||
![]()
Please forgive my ignorance, but I am a Touring car driver and new to offroad......on a medium size track what final drive ratio would be a good starting point for my DB01 using a 10x2 Turn motor? the 48dp pinions I have would give me a range of 5.1 - 8.1 ish using the kit spur.
Nice gear chart by the way.... ![]() Thanks. |
#3
|
||||
|
||||
![]()
I'm guessing you don't have / haven't built the kit yet? The kit comes with a 17t pinion (and a 23) which gives you 10.9 overall ratio. I am running a 14x2 indoors on a 21t which is 8.8 overall - probably a bit high for a 10 turn.
The 17T should be a decent start at 10.9 overall though. I've mostly run brushless in my 501X but when I've run brushed I've run around 11.1 overall on a 12x1 - maybe a bit conservative but it was indoors. |
#4
|
|||
|
|||
![]()
No, the wife has told me i'm not allowed it until tomorrow, thanks for the reply, at least I know where to start now.......
![]() And merry christmas to you. ![]() |
![]() |
Thread Tools | |
Display Modes | |
|
|